Log in to your Netgear router. This can usually be done by going to http://www.routerlogin.com/ and entering the username and password for your Netgear router. Username and password can often be found on a sticker under your router. Unless you have changed it manually, the username and password is normally admin and password by default. To configure netgear router as access point, navigate to ADVANCED ➝ Advanced Setup ➝ Wireless Settings. Check the box Enable AP Mode. Verify that Get IP Address Dynamically and Get DNS Server Address Dynamically are both checked. Click Apply. Connect a network cable between the LAN port on your Vilfo and the WAN port on your Netgear router.